Page 1 of 1

need some help for restoratio.

Posted: Sat May 24, 2014 10:06 am
by ntinos_athens
I try to restore my old oric 1 for first im lookin for pal prom ic TBP24S10N ready for use and ULA, any ideas were can find it? Thanks

Re: need some help for restoratio.

Posted: Sat May 24, 2014 11:27 am
by Chema
The ULA I think is the most difficult part. There were some units for sale on eBay recently

http://www.ebay.es/itm/HCS10017-ULA-HCS ... 1325048164

Re: need some help for restoratio.

Posted: Sun May 25, 2014 8:19 am
by highwayman
prom dump

Re: need some help for restoratio.

Posted: Fri May 30, 2014 9:54 pm
by ntinos_athens
Thanks for the .bin, i fix the oric is working again after 25+ years!! the problem was from ram, i replace all ic's and everything it's ok.
My big problem now is were can i found the tbp24s10n with the prog inside because i can't found any compatible programmer :( to write it.
Any ideas?

Re: need some help for restoratio.

Posted: Sun Jun 01, 2014 5:07 pm
by Godzil
You don't need this small ROM unless you use the RF out.

Re: need some help for restoratio.

Posted: Sun Jun 01, 2014 7:53 pm
by ntinos_athens
Wrong this prom is to mix the rgb signal from ULA and send a composite+sync pal signal to rf modul.

Re: need some help for restoratio.

Posted: Mon Jun 02, 2014 9:21 am
by Godzil
ntinos_athens wrote:Wrong this prom is to mix the rgb signal from ULA and send a composite+sync pal signal to rf modul.
That's exactly what I said. No need for this ROM until you use the RF output or if you are not using RF output, this ROM is useless.

Re: need some help for restoratio.

Posted: Mon Jun 02, 2014 10:50 am
by ntinos_athens
Ok maybe i write it wrong, the rf module need the tbp24s10n to work and send picture on tv, you can see it on schematic diagram.

Re: need some help for restoratio.

Posted: Mon Jun 02, 2014 12:05 pm
by Godzil
Yes, but nobody use the RF output nowadays. The RGB is clearly better and easier to use on modern TV/Monitor than the RF output that won't even work with DTV.

All the CHIP releated to the RF module are not necessary to make an Oric working. (And there is a lots of component that can be removed)

Re: need some help for restoratio.

Posted: Mon Jun 02, 2014 3:35 pm
by ntinos_athens
Ok i understand what you say BUT, i need to use that ic because is encoding the rgb signal from ULA an converting to Pal composite. If i dont find someone to write it for me i will try to use a GAL.

Re: need some help for restoratio.

Posted: Mon Jun 02, 2014 11:42 pm
by highwayman
do you actually need PAL?

because a lot of people just use a pc monitor and one of these.
http://www.sintron-hk.com/GBS-8220-arca ... 99965.aspx
:D

Re: need some help for restoratio.

Posted: Fri Jun 13, 2014 10:14 am
by ntinos_athens
Hello to everyone, im looking for spare original oric prom, someone to sell to me?
:wink: